new book – Pattern and Design with Synamic Symetry
Harding lathe t slotted and threaded face plate
Hardinge T-slotted faceplate . 8-7/8″ diameter , 2-3/16″ – 10 TPI threaded mount . Has lots of tapped holes was on eBay
Making a tool tray
The Dead South | Diamond Ring
Bridgeport milling machine table covers
Mixing Console Object Model
Sony MX-12
Cutting a sharpie marker in half
World’s greatest Tap wrench – Starrett 174
Shop tour 20210404
Crazy Chord
Sheet metal Camera holder
New Sheet metal tool – 30″ brake, shear , roll
Wbsps.ca – CK-101 switch maintenance kit
TECALEMIT NO CG3020 Alternative to Zerk type oiler for bridgeport milling machine
To oil the ways of the mill, oil must be applied daily. in order to do this (conveniently) most mills are fit with a hand pump that pushes oil through the machine through a series of pipes. my vintage machine does not have that…so a handhelf oiler must be used. Normally these come from zerk but I found an alternative in this vintage British made grease pump. Works a charm!
TECALEMIT NO CG3020
$20 on eBay, $100 in shipping and bs
New hire – doing some transistor changes
Trimming glass scales for milling machine
A new spin on Braun
BRAUN AND VIRGIL ABLOH COLLABORATE TO CELEBRATE 100 YEARS OF ‘GOOD DESIGN
World Stage in AES Standards Webinar Series
This is exciting… I’m presenting in September
In the fourth webinar on September 20, Anthony Kuzub will discuss the new AES72 standard from SC-05-02 for transporting either analog or digital audio over quad twisted pair cable, including documentation of RJ45 connector pin-outs.
Http://www.aes.org/blog/2021/3/audio-standards-and-interoperability-in