Category Archives: Mechanical
Roper Whitney model 29 tools and dies
Roper Whitney model 29 kick press
5 Ton, ROPER WHITNEY, model #29, 10″ throat, foot-operated, 1″ stroke
Model number 29
SPECIFICATIONS:
Rated capacity 5 tons
Punch capacity 2″ hole thru 16 ga.
Depth of throat 10″
Height of throat 5-3/4″
Stroke of ram 1″
Hole in ram 1″
Bed dimensions 4-1/2″ x 8-1/4″
Floor space 18″ x 25″
Shipping weight, approx. 375 lbs.
Work bench gone – roll around cart now!
I had
Pem Fasteners, nuts, standoffs, Studs and Pins For Sheet Metal and PCBs
https://www.pemnet.com/fastening-products/pem-self-clinching-fasteners-new/
EVENTIDE FL201 flanged – panel recreation
Canadian drill press B-126
lathe tooling – used is best
Image
A great Lathe score includes hand ground tools. This is where someone hand grinds a shape or a pattern to accomplish a very fine detail for a feature.
5C fixture plate for the Hardinge Lathe
Redirect – www.AngryInventor.com – not a Mad Scientist but and Angry Inventor
I’m called a mad scientist often… I say I’m an 
Mitutoyo – Machinist tool maker microscope
The Saskatoon Shop
Evaporust – Scribe Stand
Amazing remover of rust. Recyclable… It’s a tool in the shop now!
Adding A Cross Cut slide to an Elgin Hardinge Lathe
Work Bench Rebuild
Engraving initials into a brass Hammer
Tool post and Holder
Piston Type Tool Post & Tool Holder Sets For 12″ Lathe
Complete with 5 quick change tool holders
Turning and facing: 3/16″ – 1/2″ tool bit
Boring, turning and facing: 7/16″ shank
Heavy duty boring bar: 5/8″ shank
Knurling, turning and facing: 3/16″ – 1/2″ tool bit
Easy tool set up to speed production
Weight: 5.5kg.
https://www.busybeetools.com/products/tool-post-quick-change-for-12in-lathe.html
Garage Crane
Hardinge Lathe 204 frame Motor
Looking to replace the 204 frame motor I watched my favorite teach on the subject
and that pointed me to the plate on the motor I have
Reading deeper into this, this is an OLD style of motor frame. 204 Stopped being used in 1953… Of course, mine is a discontinued motor frame…
Looking more at this I see the 203 and the 204 frames are similar it’s the screw mounting width that is different. I think an adapter plate could work. The only dimension that matter is D and U. U is 3/4″ so the center of the motor must be 5″ from the bottom of the plate. Obviously P must be smaller or equal. Watch out for the boxes that stick off the side for the wiring to enter.
LOOKING AT A MODERN NEMA CHART:
All the newer motors have 7/8 shaft meaning the pully will also need to be changed. The 145T looks interesting… Some shopping:
There is hope.
there are charts for the motor mount brackets:
ELGIN Hardinge Super precision lathe – Part 2 – Three-phase two-speed constant torque motor with reverse
