6″ UNIVERSAL TABLE 204-1

204-1, designed for general all-around small instrument and tool work. Work table is 6″ diameter, accurately graduated to 360 degrees; has four 3/8″ T-slots milled from solid. Can be revolved by hand and clamped in position by lever. 1/2″ hole in center of table permits centering work; bottom of hole is tapped 1/2″ N.C. for holding down work with screw or drawbar. Overall table height (horizontal position) 3-7/8″. Four holes in table top are tapped 1/4″ N.C. for use in attaching Universal Chuck 685-2 listed below.

SWIVEL, graduated through 90 degrees, permits table to be set at any angle from vertical to horizontal and revolved while in these positions. Front edge of base is machined for squaring up work with machine table.

INDEX DIAL on bottom of spindle on which table rotates; desired graduations or index points for letter cutting can be laid out with pencil lines on paper band and clipped around spindle, then indexed by means of pawl. Index dials can be furnished with any desired number of notches on special order at slight additional cost but such work can best be done with Work Holder 256-3 on Page 32. Table complete as shown with index band holder, clamp, 25 index bands. Shipping weight 25 lbs.